In this tutorial, we are going to learn about Circuit for Automatic Battery Charge Circuit Auto Cut Off 12v Charger.
Working of Automatic Battery Charge Circuit Auto Cut Off 12v Charger
Here below is the circuit for the Automatic Battery Charge Circuit Auto Cut Off 12v Charger, as per the circuit when we connect any 12-volt battery with Charger then the battery is charged but we will need Circuit Auto Cut Off 12v Charger to do some work. This Auto Cut Circuit will be cut automatically when the battery is full. When your battery is down. Then it will start working again.
Bill of Materials for Automatic Battery Charge Circuit Auto cut off 12v Charger
- 12v DC Relay
- Red and green led Indicator
- B547 Transistor
- 100k Pre-Set
- 1k Resistor
- 1.5K Resistor
PCB Layout of Automatic Battery Charge Circuit Auto Cut off 12v Charger
1. Input And Output(+)
The wire is to be connected from the Preset key to the B547 Transistor Emitter and this wire (+) is to be removed by connecting it to the 1k resistor.
2. Input and Output (-)
Connecting the wire with the Relay Common Coil is to do the Minus Input and Output (-) is to be taken out from the LED.
3. B547 Transistor
With Emitter (+) wire, Base – Preset wire and Colleter are to be installed on the coil of Relay. Both the LED’s have to be connected with the register by connecting (+). Check the diagram of the automatic battery charger auto cut properly.
Advantages of Automatic Battery Charge Auto Cut Off 12v Charger
There are many benefits of making Auto Cut Charger. We all know that when the battery is down, it does not get charged quickly and when it is connected with more surgeons, then the battery becomes dead. Therefore the circuit of Automatic Battery Charger auto cut 12volt will be useful.
After making the auto cut head water, you will not need to charge and remove the battery, this circuit will work automatically. The charge will be turned on when the battery is down. An automatic power cut will be done when the battery charge is full.